Table of Contents
Advertisement
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
l To configure the number of test packets sent each time, run the jitter-packetnum number
l To configure the interval for sending test packets, run the interval { milliseconds interval |
l To configure the percentage of the failed NQA tests, run the fail-percent percent command.
l To send the NQA test packet without searching the routing table, run the sendpacket
Step 8 Run:
start
The NQA test is started.
Select the start mode as required because the start command has several forms.
l To perform the NQA test immediately, run the start now [ end { at [ yyyy/mm/dd ]
l To perform the NQA test at the specified time, run the start at [ yyyy/mm/dd ] hh:mm:ss
l To perform the NQA test after a certain delay period, run the start delay { seconds second
----End
6.12.4 Checking the Configuration
After configuring the jitter test, you can view the test result.
Prerequisites
The configurations of the Jitter Test function are complete.
Issue 02 (2012-03-30)
command.
The Jitter test is used to collect statistics and perform analysis of the transmission delay
variation of the UDP packets. The system sends multiple test packets for each test to make
the statistics more accurate. The more test packets are sent, the more accurate the statistics
and analysis are. This process, however, is time consuming.
NOTE
The number of the Jitter tests depends on the probe-count command. The number of test packets sent
during each test depends on the jitter-packetnum command. During the actual configuration, the
product of the number of test times and the number of the test packets must be less than 3000.
seconds interval } command.
The shorter the interval for sending the Jitter test packets is, the faster the test is completed.
If the interval, however, is set to a very small value, the jitter statistics result may have a
greater error.
passroute command.
hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime { seconds second | hh:mm:ss } } ]
command.
The test instance is started immediately.
[ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime
{ seconds second | hh:mm:ss } } ] command.
The test instance is started at a specified time.
| hh:mm:ss } [ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } |
lifetime { seconds second | hh:mm:ss } } ] command.
The test instance is started after a certain delay.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
175
Advertisement
Table of Contents
