Checking The Configuration; Configuring The Trap Function; Establishing The Configuration Task - Huawei AR150/200 Series Configuration Manual

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
The uni-directional transmission (from the destination to the source) delay threshold is
configured.
----End

6.15.3 Checking the Configuration

After setting the one-way transmission delay threshold, you can view the configuration.
Prerequisites
The configurations of the Uni-directional Transmission Delay Thresholds Test function are
complete.
Procedure
Step 1 Run the display nqa-agent [ admin-name test-name ] [ verbose ] to view the status of the test
instance configured on the NQA client.
----End
Example
Using the display nqa-agent [ admin-name test-name ] [ verbose ] command, you can view the
uni-directional transmission delay threshold configured for the NQA test. For example:
<Huawei> display nqa-agent verbose
NQA Tests Max:64
NQA Flow
nqa test-instance admin jitter
test-type jitter
destination-address ipv4 100.1.1.201
destination-port 80
send-trap probefailure
send-trap testfailure
send-trap testcomplete
send-trap rtd
send-trap owd-sd
send-trap owd-ds
threshold owd-sd 2000
threshold owd-ds 2000
nqa status : normal

6.16 Configuring the Trap Function

This section describes how to configure the trap function in an NQA test instance. After the trap
function is configured, a trap message is sent to the NMS in case of transmission success or
transmission failure.

6.16.1 Establishing the Configuration Task

Before configuring the trap function, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the required data. This can help you complete
the configuration task quickly and accurately.
Issue 02 (2012-03-30)
NQA Tests
Max:1000 NQA Flow Remained:1000
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Number: 1
6 NQA Configuration
186