Enabling The Rmon Statistics Function On The Interface - Huawei AR150/200 Series Configuration Manual

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
Pre-configuration Tasks
Before configuring RMON, complete the following tasks:
l
l
Data Preparation
To configure RMON, you need the following data.
No.
1
2
3
4
5
6

2.2.2 Enabling the RMON Statistics Function on the Interface

You need to enable traffic statistics function on the interface where traffic statistics are collected.
If the traffic statistics function is not enabled on the interface, statistics values of in both
ethernetStatsTable and HistoryControlTable are 0.
Context
Do as follows on the router on which traffic statistics should be collected:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface ethernet interface-number
The interface view is displayed.
Step 3 Run:
rmon-statistics enable
The RMON statistics function is enabled on the interface.
Issue 02 (2012-03-30)
NOTE
RMON only stores traffic statistics and information or abnormalities but cannot avoid the generation of
these statistics or information. To clear abnormalities, you need to adopt the other management measures.
Configuring parameters for Ethernet interfaces
Configuring basic SNMP functions
Data
Interface on which the statistics function is enabled
Statistics table to be used and related parameters
HistoryControl table to be used and related parameters
Event table to be used and related parameters
Alarm table to be used and related parameters
Prialarm table to be used and related parameters
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 RMON Configuration
46