Table of Contents
Advertisement
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
Context
Do as follows on the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
snmp-agent
The SNMP agent function is enabled.
Step 3 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 4 Run:
test-type snmp
The test type is set to SNMP Query.
Step 5 Run:
destination-address ipv4 ip-address
The destination IP address, that is, the IP address of the SNMP agent, is configured.
Step 6 (Optional) Perform the following as required to configure other parameters for the SNMP test
( For detailed parameter configurations, see the chapter
Parameters
l To configure the VPN instance to be tested, run the vpn-instance vpn-instance-name
l To configure the source IP address, run the source-address ipv4 ip-address command.
l To configure the source port number, run the source-port port-number command.
l To configure the interval for sending test packets, run the interval seconds interval
l To configure the percentage of the failed NQA tests, run the fail-percent percent command.
l To configure the NQA test packets to be sent without searching the routing table, run the
Step 7 Run:
start
The NQA test is started.
Select the start mode as required because the start command has several forms.
Issue 02 (2012-03-30)
NOTE
The SNMP function must be enabled on the destination host; otherwise, the destination host fails to receive
Echo packets.
):
command.
command.
sendpacket passroute command.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
Configuring Universal NQA Test
164
Advertisement
Table of Contents
