Huawei AR150/200 Series Configuration Manual page 226

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need to configure the IP address of the SNMP agent.
Procedure
Step 1 Configure reachable routes between Router A, Router B, and Router C. (The detailed procedure
is not mentioned here.)
Step 2 Enable SNMP agent on Router C.
<RouterC> system-view
[RouterC] snmp-agent
Step 3 Enable SNMP agent on Router A.
<RouterA> system-view
[RouterA] snmp-agent
[RouterA] quit
Step 4 Create an SNMP Query test on Router A.
<RouterA> system-view
[RouterA] nqa test-instance admin snmp
[RouterA-nqa-admin-snmp] test-type snmp
[RouterA-nqa-admin-snmp] destination-address ipv4 10.2.1.2
Step 5 Start the test.
[RouterA-nqa-admin-snmp] start now
Step 6 View the test results.
[RouterA-nqa-admin-snmp] display nqa results test-instance admin snmp
NQA entry(admin, snmp) :testflag is inactive ,testtype is snmp
1 . Test 1 result
----End
Configuration Files
l
Issue 02 (2012-03-30)
Configure Router A as an NQA client.
Enable SNMP agent on Router A.
Create and perform an SNMP Query test on Router A.
Enable SNMP agent on Router C.
The test is finished
Send operation times: 3
Completion:success
Attempts number:0
Disconnect operation number:0
System busy operation number:0
Operation sequence errors number:0
Destination ip address:10.2.1.2
Min/Max/Average Completion Time: 63/172/109
Sum/Square-Sum Completion Time: 329/42389
Last Good Probe Time: 2006-8-5 15:33:49.1
Lost packet ratio: 0 %
Configuration file of Router A
#
sysname RouterA
#
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Receive response times: 3
RTD OverThresholds number: 0
Drop operation number:0
Operation timeout number:0
Connection fail number:0
RTT Stats errors number:0
6 NQA Configuration
215