Table of Contents
Advertisement
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
6.20.2 Example for Configuring the DHCP Test
This part provides examples for configuring a DHCP test to detect the speed at which a DHCP
server that sets up a connection with an NQA agent obtains the IP address.
Networking Requirements
As shown in
DHCP test to obtain the time taken by the DHCP server to allocate an IP address to the client.
Figure 6-4 Networking diagram of the DHCP test
R o u te r A
N Q A a g e n t
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
Procedure
Step 1 Configure the IP address. (The detailed procedure is not mentioned here.)
Step 2 Enable the NQA client and create an NQA DHCP test.
<RouterA> system-view
[RouterA] nqa test-instance admin dhcp
[RouterA-nqa-admin-dhcp] test-type dhcp
[RouterA-nqa-admin-dhcp] source-interface ethernet 1/0/0
[RouterA-nqa-admin-dhcp] timeout 20
Step 3 Start the test.
[RouterA-nqa-admin-dhcp] start now
Issue 02 (2012-03-30)
interface Ethernet1/0/0
ip address 10.1.1.2 255.255.255.0
#
return
Figure
6-4, Router B functions as a DHCP server. It is required to perform an NQA
E th 1 /0 /0
1 0 .1 .1 .2 /2 4
Configure Router A as the NQA client.
Create and perform the DHCP test on Router A to check whether Router A can set up a
connection with Router B and obtain an IP address from Router B.
IP address of the DHCP server
Source interface
Timeout period
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
R o u te r B
E th 1 /0 /0
D H C P S e rv e r
6 NQA Configuration
203
Advertisement
Table of Contents
