Huawei AR150/200 Series Configuration Manual page 149

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
6.10 Configuring the TCP Test
This section describes how to configure a Transmission Control Protocol (TCP) test to check
the responding speed of a TCP port.
6.11 Configuring the UDP Test
This section describes how to configure a User Datagram Protocol (UDP) test to check the
responding speed of a UDP port.
6.12 Configuring the Jitter Test
This section describes how to configure a jitter test to check jitter on the network. You can
perform a jitter test only when both the client and the server are Huawei devices.
6.13 Configuring Universal NQA Test Parameters
This section describes how to set and use universal parameters for NQA test instances.
6.14 Configuring Round-Trip Delay Thresholds
This section describes how to set a round-trip delay transmission threshold in an NQA test
instance.
6.15 Configuring Uni-directional Transmission Delay Thresholds
This section describes how to set a one-way transmission delay threshold in an NQA test
instance. After a one-way transmission delay threshold is set in an NQA test instance, the test
result will contain the statistics on the test packets that exceed the set threshold. This provides
the basis for the network manager to analyze the operating status of the specified service on the
network.
6.16 Configuring the Trap Function
This section describes how to configure the trap function in an NQA test instance. After the trap
function is configured, a trap message is sent to the NMS in case of transmission success or
transmission failure.
6.17 Configuring Test Results to Be Sent to the FTP Server
This section describes how to configure the system to send test results to the FTP server to avoid
loss of test results in the event that the NMS does not poll the test result in time.
6.18 Configuring a Threshold for the NQA Alarm
This section describes how to set an alarm threshold for test results. When the number of test
results exceeds the threshold, a trap message is sent to the NMS for notification.
6.19 Maintaining NQA
This section describes how to maintain an NQA test instance. You can restart the test instance
and clear the statistics on the test result to maintain a test instance.
6.20 NQA Configuration Examples
This section provides examples for configuring NQA and illustrates the networking
requirements, configuration roadmap, and configuration notes. You can better understand the
configuration procedures with the help of the configuration flowchart.
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
138