Checking The Configuration - Huawei AR150/200 Series Configuration Manual

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
l To configure the NQA test packets to be sent without searching the routing table, run the
Step 7 Run:
start
The NQA test is started.
Select the start mode as required because the start command has several forms.
l To perform the NQA test immediately, run the start now [ end { at [ yyyy/mm/dd ]
l To perform the NQA test at the specified time, run the start at [ yyyy/mm/dd ] hh:mm:ss
l To perform the NQA test after a certain delay period, run the start delay { seconds second
The differences between the TCP Public tests and the TCP Private tests are as follows:
l The TCP Public tests do not require the destination port to be configured on the client.
l The TCP Private tests require the destination port be specified and the related monitoring
----End

6.10.4 Checking the Configuration

After configuring the TCP test, you can view the test result.
Prerequisites
The configurations of the TCP Test function are complete.
Context
Procedure
l
l
----End
Issue 02 (2012-03-30)
sendpacket passroute command.
hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime { seconds second | hh:mm:ss } } ]
command.
The test instance is started immediately.
[ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime
{ seconds second | hh:mm:ss } } ] command.
The test instance is started at a specified time.
| hh:mm:ss } [ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } |
lifetime { seconds second | hh:mm:ss } } ] command.
The test instance is started after a certain delay.
Connection requests are initiated and sent to the TCP port 7 of the destination address. The
server should monitor the TCP port 7.
services enabled on the server.
NOTE
NQA test results cannot be displayed automatically on a terminal. You must run the display nqa results
command to view test results. By the default, the command output contains the records about only the last
five tests.
Run the display nqa results [ test-instance admin-name test-name ] command to view the
test results on the NQA client.
Run the display nqa-server command to view the information about the NQA server.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
168