Setting The Destination Address Of The Statistics; Optional) Configuring The Inactive Aging Time - Huawei AR150/200 Series Configuration Manual

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ip netstream export version 9 [ origin-as | peer-as ] [ bgp-nexthop ]
The version of exported statistics packets is set to V9.
By default, the version of exported packets is v5, the AS option is none, and the statistics do not
contain the information about the BGP nexthop.
----End

7.6.4 Setting the Destination Address of the Statistics

This section describes how to send the IPv4 unicast traffic statistics to the NMS for analysis.
Context
You cannot export the NetStream statistics without the pre-configured source and destination
addresses.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ip netstream export source ip-address
The source address for exporting statistics is configured.
Step 3 Run:
ip netstream export host ip-address port-number
The destination IP address of the exported statistics, that is, the IP address of the NSC, is
configured.
You can configure up to 2 destination addresses to implement the backup between 2 NSCs.
----End

7.6.5 (Optional) Configuring the Inactive Aging Time

The inactive time indicates the interval between the time the last packet arrives and the current
time. When the inactive time expires, the system ages the traffic immediately.
Issue 02 (2012-03-30)
NOTE
At present, only the packets of v9 contain the information about the BGP nexthop.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 NetStream Configuration
244