Configuring Uni-Directional Transmission Delay Thresholds - Huawei AR150/200 Series Configuration Manual

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
Data Preparation
To configure the uni-directional transmission delay threshold, you need the following data.
No.
1
2

6.15.2 Configuring Uni-directional Transmission Delay Thresholds

This part describes how to set a one-way transmission delay threshold. When the transmission
duration exceeds the threshold, a trap message is sent to the NMS.
Context
Do as follows on the router to perform the NQA test:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the NQA instance view is displayed.
Step 3 Run:
test-type jitter
The test type is configured.
Step 4 Run:
destination-address ipv4 ip-address
The destination IP address is configured.
Step 5 (Optional)Run:
destination-port port-number
The destination port number is configured.
Step 6 Run:
threshold owd-sd owd-sd-value
The uni-directional transmission (from the source to the destination) delay threshold is
configured.
Step 7 Run:
threshold owd-sd owd-sd-value
Issue 02 (2012-03-30)
Data
Administrator name and test name
Uni-directional transmission delay threshold
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
185