Configuring The Udp Server; Configuring The Udp Client - Huawei AR150/200 Series Configuration Manual

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management

6.11.2 Configuring the UDP Server

The IP address and number of the port monitored by the server must be identical with those
configured on the client.
Context
Do as follows on the NQA server (UDP server):
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa-server udpecho
The UDP monitoring service is configured.
Note that the IP address and port number monitored by the server should be consistent with those
configured on the client.
----End

6.11.3 Configuring the UDP Client

This part describes how to set UDP test parameters.
Context
Do as follows on the NQA client (UDP client):
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type udp
The test type is set to UDP.
Step 4 Run:
destination-address ipv4 ip-address
Issue 02 (2012-03-30)
ip-address port-number
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
170