Configuring The Alarm Threshold; Starting The Test Instance - Huawei AR150/200 Series Configuration Manual

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management

6.18.3 Configuring the Alarm Threshold

This part describes how to configure the events triggered when the number of test results exceeds
the threshold.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
The test instance view is displayed.
Step 3 Run:
test-type { dhcp | dns | ftp | http | icmp | jitter | snmp | tcp | trace | udp }
The test type is configured.
Step 4 Run:
destination-address ipv4 ip-address
The destination IP address is configured.
Step 5 (Optional)Run:
destination-port port-number
The destination port number is configured.
Step 6 Run:
alarm entry-number { lost-packet-ratio | jitter-average | jitter-ds-average |
jitter-sd-average | packet-loss-ds | packet-loss-sd | rtt-average } { absolute |
delta } { falling-threshold threshold-value1 event-entry1 | rising-threshold
threshold-value2 event-entry2 } * [ description description ]
The alarm number and the threshold are configured.
----End

6.18.4 Starting the Test Instance

You can start a test instance. When the number of test results exceeds the threshold,
corresponding action is taken.
Procedure
Step 1 Run:
system-view
Issue 02 (2012-03-30)
NOTE
At present, only the absolute statistics function rather than the relative statistics function is supported.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
198