Checking The Configuration - Huawei AR150/200 Series Configuration Manual

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
The trap function is applied to all interfaces. The trap function can take effect no matter whether
the LLDP function is enabled globally. If the network topology is unstable, disable the LLDP
function to prevent frequent trap sending.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
snmp-agent trap enable
The trap function is enabled.
By default, the trap function is disabled on the AR150/200.
----End

3.3.8 Checking the Configuration

Prerequisites
All configurations are complete.
Procedure
l
l
l
l
----End
Example
Run the display lldp local command. The following information shows the LLDP status in the
system and on the interface, LLDP management address, and all timers.
<Huawei> display lldp local
System information
Chassis type
Chassis ID
System name
System description
RP (R) software,Version 5.100 (AR200 V200R002C00) Copyright (C) 2000-2011 Huawei
Technologies Co., Ltd
System capabilities supported
System capabilities enabled
LLDP Up time
MED system information
Issue 02 (2012-03-30)
NOTE
A reachable route exists between the AR150/200 and the network management system and the SNMP
parameters are set before enabling the LLDP trap function.
Run the display lldp local [ interface interface-type interface-number ] command to view
local LLDP status.
Run the display lldp neighbor [ interface interface-type interface-number ] command to
view neighbor information of an interface.
Run the display lldp neighbor brief command to view brief information about neighbors.
Run the display lldp tlv-config command to view the TLV types supported by the interface.
:macAddress
:00e0-11fc-1710
:Huawei
:Huawei AR200 Huawei Versatile Routing Platform Software
:2011/6/13 11:40:49
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
:bridge
:bridge
3 LLDP Configuration
V
71