Example For Collecting The Statistics Of Ipv4 Unicast Traffic - Huawei AR150/200 Series Configuration Manual

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management

7.9.1 Example for Collecting the Statistics of IPv4 Unicast Traffic

This part provides examples for configuring the IPv4 unicast traffic statistics collection.
Networking Requirements
As shown in
NetStream is enabled on Router B. The carrier thus can collect the respective statistics of
incoming and outgoing traffic on Eth1/0/0 of Router B. This provides reference for network
accounting.
Figure 7-2 Networking diagram of collecting the statistics of IPv4 unicast traffic
Network
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Configure IP addresses for the interfaces on Router A and Router B. The configuration details
are not mentioned here.
Step 2 Enable NetStream for incoming and outgoing traffic on Router B.
# Enable NetStream for outgoing traffic on Router B.
<Huawei> system-view
[Huawei] sysname RouterB
[RouterB] interface ethernet 1/0/0
[RouterB-Ethernet1/0/0] ip netstream outbound
# Enable NetStream for incoming traffic on Router B.
[RouterB-Ethernet1/0/0] ip netstream inbound
Issue 02 (2012-03-30)
Figure 7-2, the user network accesses carrier'sRouter B through Router A.
Eth1/0/0
User
10.1.1.1/24
Router A
Configure IP addresses for the interfaces on router.
Enable NetStream for incoming and outgoing traffic on Router B.
IP addresses of the interfaces
Destination address, source address, and destination interface of the output statistics
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Eth2/0/0
NSC&NDA
10.2.1.1/24
10.2.1.2/24
Eth1/0/0
10.1.1.2/24
Router B
7 NetStream Configuration
ISP
252