Huawei AR150/200 Series Configuration Manual page 98

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
The NMS has reachable routes to RouterA and RouterB and SNMP parameters are set on all
devices.
Figure 3-9 Configuring LLDP on the network where link aggregation is configured
Enterprise
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Configure the Eth-Trunk between RouterA and RouterB.
# Configure RouterA.
<Huawei> system-view
[Huawei] sysname RouterA
[RouterA] vlan batch 100
[RouterA] interface eth-trunk 1
[RouterA-Eth-Trunk1] trunkport ethernet 0/0/0 to 0/0/2
[RouterA-Eth-Trunk1] port link-type trunk
[RouterA-Eth-Trunk1] port trunk allow-pass vlan 100
[RouterA-Eth-Trunk1] quit
Issue 02 (2012-03-30)
RouterA
User
10.10.10.1
Add the physical interfaces of RouterA and RouterB to the Eth-Trunk.
Enable global LLDP on RouterA and RouterB.
Configure management addresses for RouterA and RouterB.
Management address 10.10.10.1 for RouterA and management address 10.10.10.2 for
RouterB
Number of the Eth-Trunk between RouterA and RouterB, and numbers of the interfaces
added to the Eth-Trunk
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
NMS
Network
Eth-Trunk
RouterB
10.10.10.2
3 LLDP Configuration
Enterprise
User
87