Configuring A Rule For An Ethernet Frame Header Acl - HP 1920 Series User Manual

Configuring a rule for an Ethernet frame header ACL

1.
2.
Downloaded from www.Manualslib.com
Item
TCP Connection
Established
Source
TCP/UDP Port
Destination
DSCP
TOS
Precedence
Filter
Precedence
Time Range
Select QoS > ACL IPv4 from the navigation tree.
Click the Link Layer Setup tab.
The rule configuration page for an Ethernet frame header IPv4 ACL appears.
manuals search engine
Description
Select this box to make the rule match packets used for
establishing and maintaining TCP connections.
These items are available only when you select 6 TCP from the
Protocol list.
Operator Select the operators and enter the source port numbers and
destination port numbers as required.
Port
These items are available only when you select 6 TCP or 17 UDP
Operator
from the Protocol list.
Different operators have different configuration requirements for
the port number fields:
•
Not Check—The following port number fields cannot be
configured.
•
Range—The following port number fields must be configured
Port
to define a port range.
•
Other values—The first port number field must be configured
and the second must not.
Only Not Check and Other values are supported.
Specify the DSCP value.
Specify the ToS preference.
Specify the IP precedence.
Select the time range during which the rule takes effect.
459
If you specify the ToS
precedence or IP precedence
when you specify the DSCP
value, the specified TOS or IP
precedence does not take
effect.