Indicator Light - Toyota ZZT230 series Repair Manual

INSPECTION PROCEDURE
"M" position Indicator light flashes.
When the ATF temperature is too high or low, the M position indicator light flashes. If this happens, shift the
shif t lever to the
the M p osi t ion
If
shift main switch circuit.
mission
"M" position Indicator light does not light up.
1 Check operation of
N
) c:J
Check E-shlft main switch.
2
N
DIAGNOSTlCS
0 It
position and shift back to the M position after the ATF temperature increase or decrease.
Indicator light is still flashing, check if DTC
M

Indicator light.

oo=•
\
007811
-
AUTOMATIC TRANSAXLE
is displayed or not and inspect the trans­
P0710
CHECK:
Check if the M indicator light normally when the shift lever is set
OK:
to 0 position and M position.
Shift Lev91' Position
M
B G
BE-2).
CHECK:
Check continuity between each terminal of the E-shift shift
OK:
main switch.
Shift Lever Position
M
Exc M
If the continuity is not as specified, replace the switch.
Specified Condition
'M" indiCator light comes on
"M" indicator light goes off
.
Tester connectiOn Specified
3 - 4 Continuity
3 - 4 Nocontinul
01-217
value