Toyota ZZT230 series Repair Manual page 477

Dl-266
INSPECTION PROCEDURE
Measure resistance between terminal ST of ECM a;td body ground.
1
N
2 Measure harness and connector between ECM and automatic transaxle solenoid
connector.
N
3 Check connection of the connectors.
-
PREPARATI O N:
CHECK:
Disconnect the connector from ECM.
Measure resistance between terminal
OK: Resi s tance: 11 -15 nat
ground.
8
Chock and repl a ce the ECM See page
PREPARATI O N:
Disconnect the solenoid connector from the automatic trans�
CHECK:
axle.
Measure the harness and connector between terminal
OK:
ECM and terminal of solenoid connector.
ST
G
Repai r or repl a ce tho harness or connector.
G
Connect the connectors correctl y .
of ECM and body
ST
( 6 8 'F)
'c
20
IN--1 0 ).
ST
of