Toyota ZZT230 series Repair Manual page 692

Check voHage between terminal Tc of DLC3 and body ground.
3
0 0N
Check alrbag sensor assembly.
LOCK
(§)
)
Airbag Sensor Assembly
ooo
""�
A80117 A8011&
Repl a ce al r bag senso r assem bl y .
D AGNOSTlCS
CHECK:
Measure the voltage between terminal T c of DLC3 and body
OK:
ground.
-
Vol t age:
"'""'
ON
PREPARATION:
Turn the ignition switch to LOCK.
(a)
0
Disconnect negative (-) terminal cable from the battery,
(b)
and wait at least for 90 seconds.
Disconnect the airbag sensor assembly connector.
(c)
Insert service wire into terminal Tc from back side as
(d)
shown in the illustration.
(e) Connect the airbag sensor assembly connector with ser·
vice wire.
Connect negative (-) terminal cable to the battery.
(f)
Turn the ignition switch to
(g)
conds.
CHECK:
Connect service wire of terminal Tc to body ground.
(h)
1112918
OK: SRS wani n g l i g ht comes on.
Check operation of the SRS warning light.
Pay due att e nt i o n to the termi n al connect i n g posi t i o n to
NOTICE:
avoi d a mal f unct i o n.
SUPPLEMENTAL RESTRAINT SYSTEM
10- 14 v
Check harness bet w een termi n al E1 of DLC3
and body gr un
o d.
ON
Check harness bet w een the ai r bag sensor as-
sembl y and DLC3.
Dl-481
and wait at least for 20 se-