Toyota ZZT230 series Repair Manual page 662

Check alrbag sensor assembly.
7
Door Side Airbag
(LH)
S ensor
-H-
0
DLC3
Tc
CG
-
AB0118
)
resuHs of the above I n specti o n, the mal f uncti o ni n g part can now
sure of thi s , usa the si m ul a ti o n method to check.
From the
To make
)
DIAGNOSTICS
Airbag
Sensor
Assembly
-+ <-
ON
DTC 81144/81145135
SUPPLEMENTAL RESTRAINT SYSTEM
PREPARATI O N:
(a) Turn the ignition switch to LOCK.
(b) Disconnect negative (-) terminal cable from the battery,
and wait at least for 90 seconds.
(c) Connect the door side airbag sensor (LH) connector and
airbag sensor assembly connector.
{d) Connect negative {-) terminal cable to the battery, and
CHECK:
wait at least for -2 seconds.
(a) Turn the ignition switch to ON, and wait at least for 20 se�
conds.
Clear the DTC stored in memory (See page Dl-326).
(b)
Turn the ignition switch to LOCK, and wait at least for 20
(c)
( d )
seconds.
T u
n the Ignition switch to ON, and wait at least for 20 se­
r
conds.
OK: DTC
(e) Check the DTC (See page Dl-326).
I s not output.
35
HINT:
Codes other than code 35 may be output at this time, but they
are not relevant to this check.
G I
Repl a ce al r beg sensor assembl y .
Dl-451
consi d e r ed
be normal.