Toyota ZZT230 series Repair Manual page 745

Actuator Control Cable
INSPECTION PROCEDURE
Actuator control cable Inspection
1
Check that the actuator and control cable throttle link are properly installed and that the cable and link
(a)
are connected correcUy.
Check that the actuator and bell crank operate smoothly.
(b)
Check that the cable is not loose or too tight.
(c)
•
HI N T:
then 10 mm
Free pl ay:
tess
•
If the control cable Is very
If the control cable is too tight. the idle
loose,
the vehicle's loss of speed going uphill will be large.
RPM
will become high.