01-420
Check PIT squib (LH).
4
PIT
Ai r bag
Sensor
Assembl y
DLC3
=
�
Tc
CG
H0\018
AS0\19
H\0600 H0\01:16
From the results of the above Inspection, the malfunctioning part can now
To make sure of this, use the simulation method to check. If the malfunctioning part can not
detected by the simulation method, replace all SRS components Including the wire harness.
DIAGNOSTICS
PREPARATION:
(a) Turn the ignition switch to LOCK
(b) Disconnect negative (-) terminal cable from the battery,
and wait at least for 90 seconds.
(c) Connect the seat belt pretensioner (LH) connector.
(d) Connect negative (-) terminal cabl e to the battery, and
wai t at l e ast for 2 seconds.
CHECK:
(a) Turn the ignition swi t ch to ON, and wai t at l e ast for 20 se
conds.
(b) Cl e ar the DTC stored i n memory
(See step
DTC 80138n2
(c) Turn the ignition switch to LOCK, and wait at least for 20
seconds.
(d) Turn the ignition switch to ON, and wait at least for 20 se
conds.
(e ) Check the DTC (See page Dl-326).
OK:
DTC 80138/72 Is not output.
HINT:
Codes other than code B0138/72 may be output at thi s time, but
they are not relevant to this check.
on page Dl-326).
5
Replace seat belt pretensloner (LH).
be
considered normal.
be