Dl-66
CONFIRMATION DRIVING PATTERN
Connect the TOYOTA hand-held tester or OBD II scan lool.
(a)
Use
(b )
Record DTC and the freeze frame data.
( c )
the TOYOTA hand-held tester to set to Check Mode (See page Dl-3).
Drive the vehicle several times with the engine speed, load and its surrounding range shown with EN
(d)
GINE SPD, CALC LOAD in the freeze frame dala or MISFIRE RPM, MISFIRE LOAD in the data list.
If you have no TOYOTA hand-held tester, tum the Ignition switch OFF after the symptom is simulated
first
the
time. Then repeat the simulation process again.
HINT:
In order to memorize OTC of misfire, It is necessary to drive around MISFIRE RPM, MISFIRE LOAD in the
data list for the following period of time.
Enginlt Speed
""''
Check whether there
{e)
them.
Turn ignition switch OFF and wait at least 5 seconds.
{f)
mtsftre or not by monitonng DTC and the freeze frame data. After that, record
IS
- ENGINE
lime
3 minutes 30 seconds or more
3 minutes or more
1 minute 30 seconds or more
1
minute or more