Toyota ZZT230 series Repair Manual page 678

Check al r bag sensor assembl y .
7
Airbag
nsor flH
Se
Fronl
...
0N
0
DLC3
CG T c
From the resul t s of the above I n specti o n, the mal f uncti o ni n g
To make sure
)
Alrbag
Sensor
... Assembly
-+ <-
DTC
811581811 59/16
thi s , uss the si m ul a ti o n method to
of
-
DIAGNOSTICS
SUPPLEMENTAL RESTRAINT SYSTEM
PREPARATI O N:
(a) Turn the ignition switch to LOCK.
Disconnect negative (-) terminal cable from the battery,
(b)
and wait at least for 90 seconds.
(c) Connect the front airbag sensor
bag sensor assembly connector .
(d) Connect negative (-) terminal cable to the battery, and
CHECK:
wait at least for
Turn the ignition switch to ON, and wait at least for 20 se­
(a)
conds.
(b)
Clear the DTC stored in memory (See page 01-326).
Turn the ignition switch to LOCK, and wait at least for 20
(c)
seconds.
(d) Turn the ignition switch to ON, and wait at least for 20 se­
conds.
OK: DTC
(e) Check the DTC (See page
B1158/B1159/161 s not out p ut.
HINT:
Codes other than code 811 58/811 59/16 may be output at this
time, but they are not relevant to this check.
check.
(LH)
connector and air­
2
seconds.
Dl-326).
part can now consi d e r e d normal .
be
Dl-467