Toyota ZZT230 series Repair Manual page 596

Check side squib (LH).
Squib (LH)
DLC3
T c
HOI0$6 AB0!19
H10000 H01073
)
From the results of the above Inspection, the malfunctioning part can now
To make sure of this, use the simulation method to check.
)
DIAGNOSTICS
Airbag
Sensor
Assembly
er
DTC 80115147
H12026
-
SUPPLEMENTAL RESTRAINT SYSTEM
PREPARATI O N:
(a) Turn the ignition switch to LOCK.
(b) Di s connect negative (-) terminal cable from the battery,
and wait at least for 90 seconds.
(c) Connect the front side airbag assembly (LH) connector.
(d) Connect negative {-) terminal cable to the battery, and
wait at least for
CHECK:
2
(a) Turn the ignition swi t ch to LOOK. and wait at least for
second.
(b ) Turn the ignition switch to ON, and wait at least for 20 se-
conds.
(c) Clear the DTC stored in memory (See page
(d) Turn the ignition switch to LOCK, and wai t at least for
seconds.
(e) Turn the ignition swi t ch to ON, and wait at least for
conds.
(I) Check the DTC (See page Dl-326).
OK:
-
DTC
B0115/47 1s not output.
HINT:
Codes other than code 80115/47 may be output at this time, but
they are not relevant to this check.
Replace side alrbag assembly
seconds.
(LH) .
considered normal.
be
01-385
20
Dl-326).
20
20 se-