Toyota ZZT230 series Repair Manual page 374

)
)
-
6. BASI C I N SPECTI O N
DIAGNOSTICS AUTOMATIC TRANSAXLE (U240El
HI N T:
Check the fluid level.
(a)
Drive the vehicle so that the engine and transaxle are at
•
Fl u i d temp. :
normal operating temperature.
Only use the COOL range on the dipstick as a rough refer­
ence when the fluid is replaced or the engine does not
run.
(1)
Park the vehicle on a level suriace and set the park­
ing brake.
( 2 )
With the engine idling and the brake pedal de­
pressed, shift the shift lever into all positions from P
to L position and return to P position.
Pull out the dipstick and wipe it clean.
(3)
Push it back fully into the pipe.
(4)
Pull it out and check that the fluid level is in the HOT
(5)
range.
Fl u i d type: ATF Type T-I V
If the level is at the low side, add new fluid.
Capaci t y : 4. 1 l i t ers ( 4 . 3 US qt s , 3. 6 I m p . qt s )
NOTI C E:
Do not overf i l l .
(b) Check the fluid condition.
If the fluid smells burnt or is black, replace it.
ATF.
Replace the
(c)
(1)
Remove the drain plug and drain the fluid.
(2)
Reinstall the drain plug securely.
(3) With the engine OFF add new fluid through the oil
Fl u i d type: ATF Type T-I V
filler pipe.
Capaci t y: 4. 1 l i t ers ( 4 . 3 US qt s , 3. 6 I m p. qt s )
Start the engine and shift the shift lever into all posi­
(4)
tions from P to L position and then shift into P posi­
tion.
(158 -176 "F)
·c
70 - so
01-1 63