Toyota ZZT230 series Repair Manual page 19

IN-14
Example:
Correct
0
INTRODUCTION FOR
ALL
(ij SIDE AIRBAG ASSEMBLY
Always store a removed or new side airbag assem­
(1)
bly with the airbag deployment direction facing up.
Storing the airbag assembly with the airbag deploy­
ment direction facing down could cause a serious
accident if the airbag deploys.
(2) Never measure the resistance of the airbag squib.
(This may cause the airbag to deploy, which is very
dangerous.)
(3 } Grease should not be applied to the side airbag as­
sembly and the surface should not be cleaned with
detergents of any kind.
(4 )
Store the airbag assembly where the ambient tem­
perature remains below 93°C (200°F), without high
humidity and away from electrical noise.
{5)
When using electric welding, first disconnect the air­
bag connector (yellow color and 2 pins) under the
seat before starting work.
(6) When disposing of a vehicle or the side airbag as­
sembly atone, the airbag should be deployed using
an SST before disposal (See page Rs-43).
Perform the operation in a safe place away from
electrical noise.
Wrong
X
N21&42