Toyota ZZT230 series Repair Manual page 625

Dl-414
4
Check PIT squib (LH).
Squi b
Plf
---- -+ f-
Airbag
Sensor
DLC3 DTC B0136R4
Tc
HOIOI�
CG
ABO! 19
From the results of the above Inspection, the malfunctioning part can now
To make sure of this, use the simulation method to check.
PREPARATION:
(a) Turn the ignition swi t ch to LOCK.
(b) Disconnect negati v e (-) termi n al cable from the battery,
and wai t at least for
(c) Connect the seat belt pretensioner (LH) connector.
{d) Connect negative
wait at least for 2 seconds.
CHECK:
(a) Tum the ignition swi t ch to ON, and wait at least for 20 se·
conds.
(b) Clear the DTC s1ored
the
(c)
Turn Ignition
seconds.
(d) Turn the
ignition
conds.
(e) Check 1he DTC (See page Dl-326).
OK:
B0136n4 1s
DTC
HINT:
Codes other than code
H10&30
they are not relevant to this check.
Replace seat belt pretensloner (LH).
seconds.
90
terminal cable to the battery, and
(-}
memory (See page Dl-326).
in
switch to LOCK, and wait at least for
switch to ON, and wait at least for
not output.
may be output at this time, but
801 36/74
be
considered normal.
20
se·
20