Toyota ZZT230 series Repair Manual page 20

)
)
FOR
-
INTRODUCTION
ALL
{g) SEAT BELT PRETENSIONER
(1) Never measure the resistance of the seat belt pre­
tensioner. (This may cause the seat belt pretension­
er to activate, which is very dangerous.)
Never disassemble the seat belt pretensioner.
(2)
Never install the seat belt pretensioner in another
(3)
(4 ) vehicle.
Store the seat belt pretensioner where the ambient
temperature remains below
away from electrical noise without high humidity.
(5)
When using electric welding, first disconnect the
connector (yellow color and 2 pins) before starting
work.
When disposing of a vehicle or the seat belt preten­
(6)
sioner alone, the seat belt pretensioner should be
activated before disposal (See page 80-112). Per­
form the operation in a safe place away from electri­
cal noise.
( 7) The seat belt pretensioner is hot after activation, so
let it cool down sufficiently before the disposal.
However never apply water to the seat belt preten­
sioner.
OF
VEHICLES
80°C
IN-15
( 1 76QF) and