01430
-
MANUAL SHIFTING
9.
HINT:
With this test, it can be determined whether the trouble is within
the electrical circuit or is a mechanical problem in the transaxle.
Disconnect the solenoid wire.
(a)
Inspect the manual driving operation.
(b)
Check that the shift and gear positions correspond with
the table below.
While driving, shift through the L, 2 and D positions.
Check that the gear change corresponds to the shift posi
tion
Position
Shift
L
R
p
HINT:
If the L, 2 and D position gear positions are difficult to positions
are difficult to distinguish, do the following read test.
If any abnormality is found in the above test, the problem is in
the transaxle itself.
Connect the solenoid wire.
(c)
Cancel oul DTC (See page Dl-220).
(d)
TEST
Gear Position
,
,
,
Reverse
Pawl
lock