Toyota ZZT230 series Repair Manual page 18

Example:
Correct
0
N
)
INTRODUCTION
FOR
All
FRONT PASSENGER AIRBAG ASSEMBLY
(e)
Always store a removed or new front passenger air­
(1)
bag assembly with the airbag deployment direction
facing up.
Storing the airbag assembly with the airbag deploy­
ment direction facing down could cause a serious
accident if the airbag inflates.
Never measure the resistance of the airbag squib.
(2)
(This may cause the airbag to deploy, which is very
dangerous.)
(3) Grease should not be applied to the front passen­
ger airbag assembly and the airbag door should not
be cleaned with detergents of any kind.
{ 4 )
Store the airbag assembly where the ambient tem­
perature remains below
humidity and away from electrical noise.
(5 ) When using electric welding, first disconnect the air­
bag connector (yellow color and 2 pins) installed on
the assembly before starting work.
When disposing of a vehicle or the airbag assembly
(6)
alone, the airbag should be deployed using an SST
before disposal (See page
Perform the operation in a safe place away from
electrical noise.
Wrong
X
OF VEHICLES
93GC (200° F),
RS-- 3 0).
IN-13
without high
B02927
Z13951