Toyota ZZT230 series Repair Manual page 618

Check PIT squib (RH).
4
PIT
Squib (RH)
DLC3
� ¢�
Tc
CG
IUOIIO O H01011
� Of�
)
From the r esul t s of the above I n specti o n, the mal f uncti o ni n g p art c an now be consi d ered normal .
sure of thi s , use the si m ul a ti o n method to check.
det ected by the si m ul a ti o n method, repl a ce al l
To make
DIAGNOSTICS
Airbag
Sensor
Assembl y
.... .. .
DTC 80133162
H10626
-
SUPPLEMENT AL RESTRAiNT SYSTEM
PREPARATION:
(a) Turn ignition swi t ch to LOCK.
(b) Disconnect negative (-) terminal cabl e from the battery,
and wait at l e ast for 90 seconds.
(c) Connect the seat bel t pretensioner (RH) connector .
(d) Connect negative (-) terminal cable to the battery, and
wal t at least for 2 seconds .
CHECK:
(a) Turn the ignition switch to ON, and wait at l e ast for 20 se­
conds.
(b) Clear the DTC stored in memory
(See step
on page Dl - 326).
5
(c) Turn the ignition swi t ch to LOCK, and wai t at l e ast for 20
seconds.
(d) Turn the ignition swi t ch to ON, and wait at least for 20 se·
conds.
(e) Check the DTC (See page Dl-326).
I s not out p ut .
OK:
DTC 80133162
HINT:
Codes other than code 80133/62 may be output at this time, but
they are not rel e vant to this check.
the mal f uncti o ni n g par t can not be
component s i n cl u di n g
It
SRS
0�07
(RH).
harness.
the wire