Toyota ZZT230 series Repair Manual page 641

01-430
10 Check side alrbag sensor assembly (RH).
Ai r bag
Sensor
Assembly
Side A Sensor
irbag
Assem bl y (RH)
DTC 81141133
DLC3
C G Tc
H01001
,0.001111
H1
H01061:1
From the results of the above Inspection, the malfunctioning part can now be considered normal.
To make sure of this, use the simulation method to check.
SUPPLEMENTAL RESTRAINT SYSTEM
-
PREPARATION:
(a) Turn the ignition switch to LOCK.
(b) Disconnect negative (-) terminal cable from the battery,
and wait at least for 90 seconds.
Connect the side airbag sensor (RH) to the connector that
(c)
the side airbag sensor (LH) was connected to.
(d) Connect negative (-) terminal cable to the battery, and
wait at least for 2 seconds.
CHECK:
Turn the ignition switch to ON, and wait at least for 20 se­
(a)
conds.
Clear the DTC stored in memory
(b)
5
(See step on page 01-326).
Turn the ignition switch to LOCK, and wait at least for 20
(c)
seconds.
Turn the ignition switch to ON, and wait at least for 20 se·
(d)
conds.
Check the OTC (See page 01-326).
(e)
OK:
DTC 81141/33 Is not output.
HINT:
81141/33
Codes other than code
they are not relevant to this check.
Replace side alrbag sensor assembly (RH).
may be output at this time, but