Toyota ZZT230 series Repair Manual page 609

Dl-398
4 I Check PI T squi b (RH).
Ai r bag
(RH)
Squib
Sensor
PfT
DLC3
� =
�
HQI021 CG
Tc
AB0119
H10600 H0101!2.
From resul t s of t h e above I n spect i o n, the mal f unct i o ni n g part can now
the
To make sure of thi s , use the si m ul a ti o n method to check.
DIAGNOSTICS
PREPARATI O N:
{a) Turn the ignition swi t ch to LOCK.
{b) Disconnect negative (-) terminal cable from the battery,
(c) Connect the seat bel t pretensioner (RH) connector.
(d) Connect negative (-) terminal cable to the battery, and
CHECK:
(a) Turn the ignition swi t ch to LOOK, and wai t at least for 20
(b) Turn the ignition switch to ON, and wai t at least for 20 se­
DTC 80130/63
(c) Clear the DTC stored i n memory (See page Dl-326).
(d) Turn the ignition switch to LOCK, and wal t at least for 20
(e) Turn the i g niti o n swi t ch to ON, and wait at l e ast for 20 se­
H10020
(f) Check the DTC (See page Dl-326).
OK: DTC
HINT:
Codes other than code 80130/63 may be output at this time, but
they are not rel e vant to this check.
SUPPLEMENTAL RESTRAINT SYSTEM
and wai t at least for 90 seconds.
wait at l e ast for 2 seconds.
second.
conds.
seconds.
conds.
I s not out p ut.
80130/63
consi d ered normal .
be