Toyota ZZT230 series Repair Manual page 601

D'-'190
Check alrbeg sensor assembly.
3
-+ <-
Squib
(LH)
Ai r bag
QJ
Sensor
Assembl y
F L - �
0
Fl+
DLC3
� ��
Tc
CG
DIAGNOSTICS
PREPARATI O N:
(a) Connect the connector to the airbag sensor assembly.
(b) Using a service wire, connect
(c) Connect negative (-) termi n al cable to the battery, and
CHECK:
ON
(a) Tum the ignition switch to ON and wait at least for 20 se­
(b) Clear the DTC stored in memory
80117/45
(c) Turn the ignition swi t ch to LOCK, and wai t at least for 20
OTC
(d) Turn the ignition switch to ON, and wai t at least for 20 se­
(e) Check the DTC (See page Dl-326).
OK: DTC
HINT:
Codes other than code 80117/45 may be output at thi s time, but
they are not relevant to this check.
G I Repl a ce al r bag ssnsor assembl y .
SUPPLEMENTAL RESTRAINT SYSTEM
tor {on the side airbag assembly side) between the side
airbag assembly (LH) and the airbag sensor assembly.
walt at least for 2 seconds.
conds.
(See step 5 on page Dl-326).
seconds.
conds.
I s not output.
80117/45
and of the connec-
FL-
FL+