Toyota ZZT230 series Repair Manual page 388

Check for short In harness and connector between terminal SPD of ECM connec­
2
tor and body ground.
Check voltage between terminal SPD of ECM connector and body ground.
3
)
4 Check for open In harness and connector between JiB No.
meter (See page IN-30).
)
DIAGNOS11 C S
AUTOMATIC TRANSAXLE (U240El
PREPARATION:
Disconnect the connector of the ECM.
CHECK:
Check continuity between terminal SPD of the ECM connector
and body ground.
OK: t
G
No con
t in u i y (1M
Repair or replace harness or connector.
PREPARATION:
Turn ignition switch ON.
CHECK:
Measure voltage between terminal SPD of ECM connector and
body ground.
OK:
9 - 14
Voltage:
tween JI B
Check for open In
Repair or replace harness or
Q
or higher)
V
harness and co nnect o r be-­
No. 1 and ECM (See page IN-30).
1
and combination
co nnect o r.
Dl-177