Toyota ZZT230 series Repair Manual page 647

Dl-436
DTC 81141/33
8
Side Sensor Assembly (LH)
Airba
--i +-
A
Sensor
Assembly
DlC3
DTC
.c:>
CG
Tc
From resuhs of t h e above I n specti o n, t h e mal f un c ti o ni n g part can now
To make sure thi s , use the si m ul a ti o n met h od to check.
of
the
DIAGNOSTICS -
out put
again?
PREPARATION:
(a)
rb
i a
g (b)
{c)
CHECK:
Turn the ignition switch to ON, and wait at least for 20 se·
(a)
conds.
(b)
Turn the ignition switch to LOCK, and wait at least for 20
(c)
81141/33
seconds.
Turn the ignition switch to ON, and wait at least for 20 se­
(d)
conds.
Check the DTC (See page Dl--326).
(e)
OK:
DTC 81141/33
HINT:
Codes other than code 81 1 4 1 /33 may be output at this time, but
they are not relevant to this check.
G I G o to st o p
Connect the connector to the side airbag sensor assem·
bly (LH)-
Connect the connector to the airbag sensor assembly.
Connect negative (-) terminal cable to the battery, and
wait at least for 2 seconds.
Clear the DTC stored in memory
5
(See step
on page Dl--326).
I s not output.
9.
consi d ered normal .
be