Toyota ZZT230 series Repair Manual page 562

5
6 Check harness between alrbag sensor assembly
From t he resul t s of t h e above I n spect i o n, t h e mal f uncti o ni n g par t can now
To make sure of thi s , use the si m ul a ti o n method to check.
det e ct e d
.
)
Check spiral cable.
Airt>og
Sensor
Assembly
Alrbag
Sensor
Assembly
the si m ul a ti o n met h od, repl a ce al l SRS component s I n cl u di n g the wi r e harness.
by
DIAGNOSTICS
SUPPLEMENTAL RESTRAINT SYSTEM
PREPARATI O N:
Disconnect the connector between the airbag sensor assembl y
and the spiral cabl e .
CHECK:
For the connector (on the spiral cabl e side) between the steer­
i n g wheel pad and the spi r al cabl e , measure the resi s tance be­
tween D+ and body ground.
OK: Resi s tance:
G Re pai r or r e p l a ce spi r al ca
CHECK:
For the connector (on the spiral cable side) between the spiral
n the
cabl e a d airbag sensor assembl y , measure the resi s tance
between D+ and body ground.
OK: Resi s tance:
sor assembl y and spi r al cabl e .
H10607
or Hi g her
1 Mn
.
e
l
b
and
spiral cable.
o r Hi g her
1 M.O.
consi d ered normal .
be
the mal f uncti o ni n g part can not b e
Dl-351