Toyota ZZT230 series Repair Manual page 561

Dl-350
Check D
4 I
squib.
-H-
Spiral
Cable
D Squi b
er
DLC3
�
CG
�·�
Tc
H10600 W02042
ABOI1!1
From the resul t s of the above I n specti o n, the mal f uncti o ni n g part can now
To make sure of thi s , use the si m ul a ti o n method to check. lf the mal f uncti o ni n g part can not
det e ct e d by the si m ul a ti o n method, re p l a ce al l SRS components I n cl u di n g the wi r e harness.
DIAGNOSTICS
PREPARATI O N:
(a) Turn the ignition swi t ch to LOCK.
(b) Disconnect negati v e (-) terminal cable from the battery,
(c) Connect the steering wheel pad connector.
Sensor
(d) Connect negative (-) terminal cable to the battery, and
Assembly
CHECK:
(a) Turn the ignition swi t ch to ON, and wait at least for 20 se·
(b) Cl e ar the DTC stored i n memory
DTC
80102/11
(c) Turn the ignition swi t ch to LOCK, and wai t at least for 20
(d) Turn the ignition swi t ch to ON, and wait at least for 20 se-
conds.
(e) Check the DTC (See page Dl-326).
OK:
H10(;06
.
DTC
-
HINT .
Codes other than code 80102/11 may be output at this time, but
they are not rel e vant to this check.
and wait at least for 90 seconds.
wait at least for 2 seconds.
conds.
(See step on page Dl - 326).
5
seconds.
s not out p ut.
I
80102/11
c onsi d ered normal .
be
be