Cancelling The System; Indicator Light; Testing The System - Toyota Previa Owner's Manual

After one minute, the alarm will automati-
cally stop with the starter circuit cut kept
on.
Reactivating the alarm
Once set, the system automatically resets
the alarm each time all the doors, trunk
and hood are closed after the alarm stops.
The alarm will be activated again under
the following conditions.
S
If any of the front, sliding or back doors
or hood is opened
S
If the battery terminal is disconnected
and then reconnected
Stopping the alarm
Turn the ignition key from the "LOCK" to
"ACC" position. The alarm will be stopped
with the starter circuit cut kept on. Stop-
ping the alarm in this manner will keep the
alarm from being reactivated when any of
the front, sliding or back doors or hood is
opened.
Interrupting the setting
With the system set, the back door can be
opened with the key without activating or
cancelling the system. While it is open,
the front and sliding doors and hood may
be opened in addition, and the system can
be activated only by the battery terminal
disconnection.
To resume the setting, close and lock the
front, sliding and back doors and hood.
The back door must be closed with the
key removed.

CANCELLING THE SYSTEM

Unlock either front door with the key. or
unlock the sliding door with the key when
it has been closed. This cancels the sys-
tem completely and the starter circuit cut
will be cancelled at once.

INDICATOR LIGHT

The indicator light gives the following
three indications.
FLASHING—The system is set. You
need the key to open the front, sliding and
back doors and hood.
ON—The system will automatically be set
when the time comes. The front, sliding
and back doors and hood may be opened
without a key.
OFF—The system is inactive. You may
open any door and hood.

TESTING THE SYSTEM

1. Open the driver's and front passen-
ger's windows.
2. Set the system as described above.
The front doors should be locked with
the key. Be sure to wait until the indica-
tor light starts flashing.
3. Unlock one of the front, sliding and
back doors from the inside. The sys-
tem should activate the alarm.
4. Cancel the system by unlocking either
front door with the key.
5. Repeat this operation for the other
doors, trunk and hood. When testing
on the hood, also check that the sys-
tem is activated when the battery ter-
minal is disconnected and then recon-
nected.
If the system does not work properly, have
it checked by your Toyota dealer.
17