Table of Contents
Advertisement
User Manual
Quidway W1003 Series Wireless Access Device
WA1003A-RU Wireless ADSL Access Point
2.4 Network Connections
Network connections are provided through the ADSL port and the
four Ethernet ports on the back of the WA1003A-RU. See the Rear
Panel diagram above and the illustrations below for examples.
2.4.1 Connect ADSL Line
Use the ADSL cable included with the WA1003A-RU to connect it
to a telephone wall socket or receptacle. Plug one end of the cable into
the ADSL port (RJ-11 receptacle) on the rear panel of the
WA1003A-RU and insert the other end into the RJ-11 wall socket. If
you are using a low pass filter device, follow the instructions included
with the device or given to you by your service provider. The ADSL
connection represents the WAN interface, the connection to the
Internet. It is the physical link to the service provider's network
backbone and ultimately to the Internet.
2.4.2 Connect WA1003A-RU to Ethernet
The WA1003A-RU may be connected to a single computer or
Ethernet device through the 10BASE-TX Ethernet port on the rear
panel. Any connection to an Ethernet concentrating device such as a
switch or hub must operate at a speed of 10/100 Mbps only. When
connecting the WA1003A-RU to any Ethernet device that is capable of
operating at speeds higher than 10Mbps, be sure that the device has
auto-negotiation (NWay) enabled for the connecting port.
Use standard twisted-pair cable with RJ-45 connectors. The
RJ-45 port on the WA1003A-RU is a crossed port (MDI-X). Follow
standard Ethernet guidelines when deciding what type of cable to use
to make this connection. When connecting the WA1003A-RU directly
Chapter 2 Installation
2-11
Advertisement
Table of Contents
