Configuring The Device To Output Logs To A Log Host - Huawei AR150 Series Configuration Manual

Huawei AR150&200&1200&2200&3200 Series Enterprise
Routers
Configuration Guide - Device Management
Step 4 Run:
quit
Return to the user view.
Step 5 Run:
terminal monitor
Display of logs, traps, and debugging message output is enabled on the user terminal.
By default, console display is enabled and terminal display is disabled.
Step 6 Run:
terminal logging
Log display is enabled on the user terminal.
By default, log display is enabled on the user terminal.
----End

3.6.1.10 Configuring the Device to Output Logs to a Log Host

Context
After configuring the device to output logs to a log host, you can view logs saved on the log host
to monitor device running.
Pre-configuration Tasks
There is a reachable route between the device and the log host.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run the following command as required.
l Run:
info-center loghost ip-address [ channel { channel-number | channel-name } |
facility local-number | { language language-name | binary [ port ] } | { vpn-
instance vpn-instance-name | public-net } ]
The device is configured to output logs to the IPv4 log host.
l Run:
info-center loghost ipv6 ipv6-address [ channel { channel-number | channel-
name } | facility local-number | { language language-name | binary [ port ] } ]
*
The device is configured to output logs to the IPv6 log host.
By default, the device does not output logs to a log host.
The device supports a maximum of eight log hosts to implement backup among log hosts.
Issue 05 (2014-01-16) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Information Center Configuration
*
41