Configuring The Device To Output Logs To A Log Host - Huawei AR530 Series Configuration Manual

Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - Device Management
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
info-center monitor channel { channel-number | channel-name }
A channel through which logs are output to a user terminal is specified.
By default, the Router uses channel 1 to output logs to a user terminal.
Step 3 Run:
info-center source { module-name | default } channel { channel-number | channel-
name } log { state { off | on } | level severity }
A rule for outputting logs to a channel is set.
By default, channel 1 is enabled to output logs and the lowest log severity is warning.
Step 4 Run:
quit
Return to the user view.
Step 5 Run:
terminal monitor
Display of logs, traps, and debugging message output is enabled on the user terminal.
By default, console display is enabled and terminal display is disabled.
Step 6 Run:
terminal logging
Log display is enabled on the user terminal.
By default, log display is enabled on the user terminal.
----End

3.5.1.9 Configuring the Device to Output Logs to a Log Host

Context
After configuring the device to output logs to a log host, you can view logs saved on the log host
to monitor device running.
Pre-configuration Tasks
There is a reachable route between the device and the log host.
Issue 01 (2014-11-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Information Center Configuration
*
30