Dtc 11 Torque Sensor Main Circuit Failure; Dtc 13 Torque Sensor Main And Sub Circuit Failure; Dtc 15 Torque Sensor Sub Circuit Failure - Suzuki RA410 Manual

DTC 11 TORQUE SENSOR MAIN CIRCUIT FAILURE

DTC 13 TORQUE SENSOR MAIN AND SUB CIRCUIT FAILURE

DTC 15 TORQUE SENSOR SUB CIRCUIT FAILURE

1. To main fuse
2. Ignition switch
3. "P/S" fuse (30A) in fuse box
4. "IG METER" fuse (15A) in fuse box
STEP
1 Was "SYSTEM CHECK FLOW TABLE" performed?
2 Is DTC 14 or 16 indicated, too?
3 1) Check proper connection for 5-pin ("C") connec-
tor to P/S control module.
2) If OK, check torque sensor and its circuit. Refer
to ON-VEHICLE INSPECTION of TORQUE SEN-
SOR.
Is torque sensor in good condition?
C1 W
C2 Y
C3 B
C4 Bl
C5 R
5. P/S control module
6. Torque sensor
7. Connector "A"
8. Connector "C"
ACTION
ELECTRICAL POWER STEERING (P/S) SYSTEM 3B1-9
7
8
YES
Go to STEP 2.
Go to flow table corre-
sponding to each DTC
No.
Substitute a known-
good P/S control mod-
ule and recheck.
NO
Go to "SYSTEM
CHECK FLOW
TABLE" in this section.
Go to STEP 3.
Replace steering
column assembly and
recheck.