Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
1E-14 Engine Lubrication System:
Oil Pump Inspection
Inspect the oil pump in the following procedures:
1) Remove the oil pump. Refer to "Oil Pump Removal
and Installation" (Page 1E-12).
2) Rotate the oil pump by hand and check that it moves
smoothly. If it does not move smoothly, replace the
oil pump assembly.
CAUTION
!
Do not attempt to disassemble the oil pump.
The oil pump is available only as an
assembly.
Service Data
Oil Pump
Item
Oil pressure (at 60 °C, 140 °F)
Oil
Item
Engine oil type
Engine oil capacity
Tightening Torque Specifications
Fastening part
Oil pan bolt
Oil pressure switch
Oil pressure switch lead wire screw
Piston cooling oil jet bolt
Oil pump mounting bolt
Oil pump driven sprocket bolt
Reference:
For the tightening torque of fastener not specified in this section, refer to "Tightening Torque List" in Section 0C
(Page 0C-9).
email: info@motomatrix.co.uk / www.motomatrix.co.uk
B947H11506012
3) Install the oil pump. Refer to "Oil Pump Removal and
Oil Pump Drive Sprocket Removal and
Installation
Refer to "Engine Bottom Side Disassembly" in Section
1D (Page 1D-49) and "Engine Bottom Side Assembly" in
Section 1D (Page 1D-56).
Specifications
Standard
100 – 400 kPa (1.0 – 4.0 kgf/cm
at 3 000 r/min
Specification
SAE 10W-40, API SF/SG or SH/SJ with JASO MA
Change
2 800 ml (3.0/2.5 US/lmp qt)
Filter change
3 300 ml (3.5/2.9 US/lmp qt)
Overhaul
3 600 ml (3.8/3.2 US/lmp qt)
Tightening torque
N⋅m
10
14
1.5
10
10
10
Installation" (Page 1E-12).
2
, 14 – 57 psi)
kgf-m
lbf-ft
1.0
7.0
1.4
10.0
0.15
1.1
1.0
7.0
1.0
7.0
1.0
7.0
I947H1150035-01
B947H11506013
B947H11507001
Limit
—
Note
B947H11507002
Note
(Page 1E-7)
(Page 1E-10)
(Page 1E-10)
(Page 1E-11)
(Page 1E-13)
(Page 1E-13)