Evaporative Emission Control System Inspection (Only For E-33); Evap Canister; Evap System Purge Control Solenoid Valve - Suzuki GSX-R1000 Service Manual

Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
1B-14 Emission Control Devices:
11) Disconnect the surge hose (9).
9
12) Move the rear fender (front) backward.
13) Disconnect the surge hose (10).
14) Remove the bracket (11) and fuel shaft-off valve
(12).
12
Installation
Install the fuel shut-off valve in the reverse order of
removal. Pay attention to the following point:
• Install the fuel shut-off valve as shown in the EVAP
canister hose routing diagram. Refer to "EVAP
Canister Hose Routing Diagram (Only for E-33)"
(Page 1B-7).
Evaporative Emission Control System
Inspection (Only for E-33)
Refer to "Evaporative Emission Control System Removal
and Installation (Only for E-33)" (Page 1B-12).
Hose
Inspect the hoses for wear or damage. If it is worn or
damage, replace the hose with a new one.
NOTE
Make sure that the hoses are securely
connected.
email: info@motomatrix.co.uk / www.motomatrix.co.uk
I947H1120035-01
10
11
I947H1120036-01
B947H11206011

EVAP Canister

Inspect the EVAP canister for damage to the body. If any
defect is found, replace the EVAP canister with a new
one.

EVAP System Purge Control Solenoid Valve

NOTE
EVAP system purge control solenoid valve
can be checked without removing it from the
motorcycle. Refer to "DTC "C62" (P0443):
EVAP System Purge Control Solenoid Valve
Circuit Malfunction (E-33 only)" in Section 1A
(Page 1A-127).
1) Check that no air flows through both of the air inlet
and outlet ports. If air flows out, replace the EVAP
system purge control solenoid valve with a new one.
2) Connect the 12 V battery to the terminals of the
EVAP system purge control solenoid valve and
check the air flow. If air flows out, the solenoid valve
is in normal condition.
I947H1120037-01
I947H1120038-01
I947H1120039-01