Iat Sensor Removal And Installation; Iat Sensor Inspection; To Sensor Inspection; Ap Sensor Inspection - Suzuki GSX-R1000 Service Manual

Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys

IAT Sensor Removal and Installation

Removal
1) Remove the air cleaner box. Refer to "Air Cleaner
Box Removal and Installation" in Section 1D
(Page 1D-7).
2) Remove the IAT sensor (1) from the air cleaner box.
Installation
Install the IAT sensor in the reverse order of removal.
Pay attention to the following point:
• Tighten the IAT sensor screw (1) to the specified
torque.
Tightening torque
IAT sensor mounting screw (a): 1.3 N·m (0.13 kgf-
m, 1.0 lbf-ft)

IAT Sensor Inspection

Refer to "DTC "C21" (P0110-H/L): IAT Sensor Circuit
Malfunction" in Section 1A (Page 1A-55).
Inspect the IAT sensor.
NOTE
IAT sensor resistance measurement method
is the same way as that of the ECT sensor.
Refer to "ECT Sensor Inspection" (Page 1C-
4).
email: info@motomatrix.co.uk / www.motomatrix.co.uk
B947H11306013
1
I947H1130012-01
1
(a)
I947H1130013-01
B947H11306014
Engine Electrical Devices:
CAUTION
!
• The IAT sensor operative temperature
range is –30 – 120 °C (–22 – 248 °F).
• Do not heat the oil up to 120 °C (248 °F) or
more for this inspection.
IAT sensor specification
Temperature
20 °C (68 °F)
40 °C (104 °F)
100 °C (212 °F)

AP Sensor Inspection

Refer to "DTC "C22" (P1450-H/L): AP Sensor Circuit
Malfunction" in Section 1A (Page 1A-60).
AP Sensor Removal and Installation
Removal
1) Remove the front seat. Refer to "Exterior Parts
Removal and Installation" in Section 9D (Page 9D-
6).
2) Disconnect the starter relay (1) from the holder.
1
3) Disconnect the coupler (2) and remove the AP
sensor (3).
3
Installation
Install the AP sensor in the reverse order of removal.

TO Sensor Inspection

Refer to "DTC "C23" (P1651-H/L): TO Sensor Circuit
Malfunction" in Section 1A (Page 1A-68).
1C-5
Standard resistance
Approx. 2.58 kΩ
Approx. 1.14 kΩ
Approx. 0.16 kΩ
B947H11306015
B947H11306016
I947H1130014-01
2
I947H1130015-01
B947H11306017