P0230-H (Use Of Sds); P0230-L (Use Of Sds) - Suzuki GSX-R1000 Service Manual

Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
1A-100 Engine General Information and Diagnosis:

P0230-H (Use of SDS)

Step
1 1) Turn the ignition switch OFF.
2) Remove the frame covers. Refer to "Exterior Parts
Removal and Installation" in Section 9D (Page 9D-6).
3) Check the FP relay coupler (1) for loose or poor
contacts.
If OK, then check the FP relay. Refer to "Fuel Pump
Relay Inspection" in Section 1G (Page 1G-7).
Is the FP relay OK?

P0230-L (Use of SDS)

Step
1 1) Turn the ignition switch OFF.
2) Remove the frame covers. Refer to "Exterior Parts
Removal and Installation" in Section 9D (Page 9D-6).
3) Check the FP relay coupler (1) for loose or poor
contacts.
If OK, then check the FP relay. Refer to "Fuel Pump
Relay Inspection" in Section 1G (Page 1G-7).
Is the FP relay OK?
email: info@motomatrix.co.uk / www.motomatrix.co.uk
Action
1
I947H1110071-01
Action
1
I947H1110072-01
Yes
• Y/B wire shorted to Replace the FP relay
power source. with a new one.
• Y/B wire shorted to
ground.
• If wire and
connection are OK,
intermittent trouble or
faulty ECM.
• Recheck each
terminal and wire
harness for open
circuit and poor
connection.
• Replace the ECM
with a known good
one, and inspect it
again. Refer to "ECM
Removal and
Installation" in
Section 1C
(Page 1C-1).
Yes
• Y/B wire open or poor Replace the FP relay
"40" connection. with a new one.
• O/W wire open or
shorted to ground.
• R/Bl or Y/R wire open
or shorted to ground,
or poor "24"
connection.
• If wire and
connection are OK,
intermittent trouble of
faulty ECM.
• Recheck each
terminal and wire
harness for open
circuit and poor
connection.
• Replace the ECM
with a known good
one, and inspect it
again. Refer to "ECM
Removal and
Installation" in
Section 1C
(Page 1C-1).
No
No