Oil Pump Removal And Installation; Oil Pump Inspection - Suzuki 2005 GSF1200 Service Manual

1E-8 Engine Lubrication System:
Installation
Installation is in the reverse order of removal.
Pay attention to the following point:
NOTE
Before installing the oil jets, apply a light coat
of engine oil to the O-rings.
Oil Jet Inspection
Inspect the oil jet in the following procedures:
1) Remove the oil jets. Refer to "Oil Jet (For the
Cylinder Head) Removal and Installation: " and "Oil
Jet (For the Piston Cooling and Transmission)
Removal and Installation: ".
2) Make sure that the oil jets are not clogged. If they are
clogged, clean their oil passage using a wire of the
proper size and compressed air.
3) Install the oil jets. Refer to "Oil Jet (For the Cylinder
Head) Removal and Installation: " and "Oil Jet (For
the Piston Cooling and Transmission) Removal and
Installation: ".

Oil Pump Removal and Installation

Refer to "Oil Pump / Oil Pressure Regulator Removal
and Installation: in Section 1F".

Oil Pump Inspection

Inspect the oil pump in the following procedures:
1) Remove the oil pump. Refer to "Oil Pump / Oil
Pressure Regulator Removal and Installation: in
B649G11506029
Section 1F".
2) Rotate the oil pump by hand and check that it moves
smoothly. If it does not move smoothly, replace the
oil pump assembly.
CAUTION
!
Do not attempt to disassemble the oil pump
assembly.
The oil pump is available only as an
assembly.
I649G1150020-01
3) Install the oil pump. Refer to "Oil Pump / Oil Pressure
Regulator Removal and Installation: in Section 1F".
B649G11506030
B649G11506031
I649G1150021-01