Ignition Coil And Spark Plug Removal And Installation; Repair Instructions - Suzuki GSX-R1000 Service Manual

Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
Ignition Coil and Spark Plug Removal and
Installation
Removal
WARNING
!
The hot engine can burn you.
Wait until the engine is cool enough to touch.
1) Turn the ignition switch OFF.
2) Remove the air cleaner box. Refer to "Air Cleaner
Box Removal and Installation" in Section 1D
(Page 1D-7).
3) Disconnect the lead wire couplers (1).
1
CAUTION
!
Disconnect the lead wire coupler before
removing the ignition coil to avoid lead wire
coupler damage.
4) Remove the ignition coils (2).
CAUTION
!
• Do not pry up the ignition coil with a
screwdriver or a bar to avoid its damage.
• Be careful not to drop the ignition coil to
prevent short/open circuit.
email: info@motomatrix.co.uk / www.motomatrix.co.uk

Repair Instructions

B947H11806001
I947H1180005-03
2
I947H1180006-02
5) Remove the spark plugs with the spark plug wrench.
Special tool
(A): 09930–10121 (Spark plug wrench set)
Installation
Install the spark plugs in the reverse order of removal.
Pay attention to the following points:
• Screw the spark plugs into the cylinder head with
fingers, and then tighten them to the specified torque.
CAUTION
!
Do not cross thread or over tighten the spark
plug, or such an operation will damage the
aluminum threads of the cylinder head.
Special tool
(A): 09930–10121 (Spark plug wrench set)
Tightening torque
Spark plug: 11 N·m (1.1 kgf-m, 8.0 lbf-ft)
Ignition System: 1H-6
(A)
I947H1180007-03
(A)
I947H1180008-03